节点文献

低压CMOS运放的可复用设计

Reusable Design of Low Voltage CMOS Operational Amplifier

【作者】 赵现伟

【导师】 高建宁;

【作者基本信息】 西安电子科技大学 , 测试计量技术及仪器, 2009, 硕士

【摘要】 目前片上系统(SoC)大多是采用深亚微米工艺设计的。基于缩短IC设计周期的考虑,特别在数字电路系统设计中,IP设计复用(reuse)技术得到广泛的重视和发展,但对于模拟IP的设计复用技术的研究和应用则相对落后,迫切需要开展针对模拟IP的设计复用技术研究。同时随着便携式电子产品的普及,低电压设计已成为电路系统工作的基本要求。本论文设计工作来源于西安电子科技大学电路设计研究所的科研项目“模拟IP设计复用和验证技术研究”,以模拟集成电路中最基本和最重要的单元——运算放大器作为研究对象,对其在片上系统设计中的可复用和低电压设计进行深入研究。首先详细介绍了IP设计复用的重要性以及模拟IP复用的发展局限,其次针对低电压CMOS运算放大器的可复用设计要求,分别讨论并设计实现了低压运算放大器的电路设计和版图设计。基于台积电TSMC0.6umCMOS工艺,利用Cadence、Hspice等EDA工具,对所设计的低压可复用运算放大器进行了仿真验证。仿真结果表明,该运放的性能指标优良,电源电压工作范围可达5~2.5V。典型情况下,开环增益为102dB,增益带宽为6.25MHz,相位裕度88.77度,电源电压抑制比80dB,共模抑制比为72dB,可满足大多数数模混合电路及片上系统内的应用要求。本设计已成功应用于XDM02项目中,流片结果表明该低压运放工作正常。

【Abstract】 The design of System on a chip (SoC) is mostly based on the deep sub-micronatpresent. In view of shortening the cycle of IC design, especially the design of digitalcircuit system, IP design reuse technology is broadly attached importance to anddeveloped, but the research and application of analog IP design reuse technology getsbehind for digital IP. It is urgent to research and develop analog IP reuse technology.With the popularizationof portable electronics at the same time, low voltage design hasbecometheessentialrequirementofcircuitsystemforworking.The paper is based on the project, research of analog IP design reuse andverification technology, which comes from Institute of Electronic CAD of XidianUniversity.Taking operational amplifier(op amp), the most basic and important cellin the analog integrated circuit, for research object, the paper makes an intensivestudy of the reusabilityandlowvoltagedesign ofop ampinthe design of SoC.Firstly,thepaperpresentstheimportanceofIPreuse designandlimitationofanalogIPindetail;secondly, based on requirement for the reuse design of low voltage CMOS op amp, thepaper separately discusses and presents the low voltage op amp design of circuit andlayout.TheICdesignoflowvoltageopamp isbasedontheTSMC0.6umCMOSprocess,andthepre-simulationoflowvoltage reusableop amphasbeen completedbyusingtheEDA tools, such as Cadence and Hspice. The results of simulation indicate thatperformance index of this op amp is good, operatingsupply voltage range is5~2.5V.Inthe typical model, open loop gain is 102dB, gain bandwidth is 6.25MHz, phase marginis 88.77o, PSRR is 80dB, CMRR is 72dB, so the low voltage op amp can be applied inmost digital-analog mixed circuitsand SoC.This design has been applied in the projectXDM02, and also it has been taped out. The result indicates low voltage op amp is ingoodworkingorder.

【关键词】 模拟IP设计复用低电压运算放大器
【Key words】 Analog IPDesign reuseLowvoltageOperational amplifier
节点文献中: 

本文链接的文献网络图示:

本文的引文网络