节点文献

盆式橡胶支座连续梁桥抗震性能优化设计研究

Study of Optimal Design of Seismic Performance of Continuous Beam Bridge Used with Rubber Pot Bearings

  • 推荐 CAJ下载
  • PDF下载
  • 不支持迅雷等下载工具,请取消加速工具后下载。

【作者】 徐秀丽赵习刚沈小平李雪红

【Author】 XU Xiu-li1,ZHAO Xi-gang1,SHEN Xiao-ping2,LI Xue-hong1(1.College of Civil Engineering,Nanjing University of Technology,Nanjing 210000,China;2.Jiangsu Transportation Research Institute Co.,Ltd.,Nanjing 210007,China)

【机构】 南京工业大学土木工程学院江苏省交通科学研究院

【摘要】 为研究盆式橡胶支座连续梁桥的抗震性能,采用有限元法分析连续梁桥的约束方式、一联跨数及跨度等主要参数对桥梁地震响应的影响。结果表明:常规的纵向单墩固定的约束形式一般不能满足抗震要求,需采用中间多墩纵向约束,为保证桥墩的延性,需要适当增加固定支座下墩柱的配箍率;支座约束方向的水平承载力要求较高,需设置抗震销、横向挡块等保险措施;一联跨数增加,对单个墩的地震响应影响不明显;减小跨度,上部结构质量减小,地震反应减小明显。

【Abstract】 To study the seismic performance of continuous beam bridge used with pot rubber bearings,the finite element method was adopted to analyze the influence of several main parameters,including the restraint modes,numbers of spans in one continuous unit and span length of continuous beam bridge,on the seismic response of the bridge itself.The results of the analysis indicate that the conventional longitudinal restraint mode of single pier fixity generally cannot meet the anti-seismic requirements while the longitudinal restraint of multiple piers in the middle of the bridge is needed.To ensure the ductility of the piers,the stirrup ratios in the pier columns beneath the fixed bearings should be properly increased and because of the higher demand of the horizontal bearing capacity in the restraint direction of the bearings,the safety measures like the arrangement of seismic pins and transverse stoppers are required.The increase of span numbers in a continuous unit does not have much influence on the seismic response of a single pier,but when the span length and mass of the superstructure are reduced,the seismic response is apparently reduced.

【基金】 江苏省交通科学研究计划项目(08y41);南京工业大学青年教师学术基金资助项目
  • 【分类号】U442.55
  • 【被引频次】9
  • 【下载频次】300
节点文献中: 

本文链接的文献网络图示:

本文的引文网络