节点文献

T-42树脂对沉钒废水中氨氮的动态吸附及解吸研究

Research on Dynamic Adsorption and Desorption of T-42 Resin on Ammonia Nitrogen in Vanadium Precipitated Wastewater

  • 推荐 CAJ下载
  • PDF下载
  • 不支持迅雷等下载工具,请取消加速工具后下载。

【作者】 郑巧巧张一敏黄晶包申旭

【Author】 Zheng Qiaoqiao;Zhang Yimin;Huang Jing;Bao Shenxu;School of Resource and Environmental Engineering,Wuhan University of Technology;Hubei Province Key Laboratory of Mineral Resources Processing and Environment;State Key Laboratory of Environmental Protection Mineral Metallurgical Resources Utilization and Pollution Control;Hubei Collaborative Innovation Center for High Efficient Utilization of Vanadium Resources;

【通讯作者】 张一敏;

【机构】 武汉理工大学资源与环境工程学院矿物资源加工与环境湖北省重点实验室国家环境保护矿冶资源利用与污染控制重点实验室钒资源高效利用湖北省协同创新中心

【摘要】 为了了解T-42树脂吸附沉钒废水中氨氮的效果及其再生性能,研究了离子交换柱高径比、初始氨氮浓度和串联级数对吸附效果的影响,分析了等温吸附模型。此外,还研究了解吸过程中解吸剂的种类、流速、解吸剂溶液浓度对氨氮解吸效果的影响。结果表明:①当废水的流速为9 mL/min,柱高径比为21.0时,T-42树脂对氨氮的吸附效果较好,穿透点吸附量为21.91 mg/g,吸附终点吸附量为34.31 mg/g;随着初始氨氮浓度的升高,吸附量升高,处理废水量降低;氨氮浓度为1 999.56 mg/L的废水经2级串联吸附后达到一级标准(≤10 mg/L)。②T-42树脂吸附氨氮符合Langmuir等温吸附模型,吸附过程为单分子层化学吸附,在15、25、35℃下T-42树脂对氨氮的理论饱和吸附量分别为36.845 9、38.550 5、40.617 4 mg/g,温度升高有利于树脂的吸附。③在解吸剂硫酸溶液体积浓度为18%,流速为3 mL/min,解吸剂溶液用量为2.67个床层体积时,对吸附饱和的树脂上氨氮的解吸率大于99%。T-42树脂可以有效地去除废水中的氨氮,并且硫酸可以对吸附氨氮后的树脂进行解吸再生。

【Abstract】 In order to understand the adsorption effect on ammonia nitrogen in vanadium precipitated wastewater and the recycle ability of T-42 resin,the influence of ratio of height to diameter of ion exchange column,original ammonia nitrogen concentration and series number on adsorption effect were studied,and the isothermal adsorption curve of T-42 resin was analyzed. In addition,the effect of the type,flow rate and concentration of desorbents on ammonia nitrogen desorption were also studied. The results showed that:①The adsorption effect of T-42 resin on ammonia nitrogen was better when the flow rate of wastewater was 9 mL/min and the ratio of height to diameter was 21.0. The adsorption capacity at the penetration point was21.91 mg/g,and the adsorption capacity at the end point was 34.31 mg/g. The adsorption capacity of resin on ammonia nitrogen increases with original ammonia nitrogen concentration increasing,but the wastewater treated decreases. Wastewater with concentration of ammonia nitrogen 1 999.56 mg/L meets the standard Class One(≤10 mg/L) by two-stage series adsorption. ②The adsorption of ammonia nitrogen by resin matches the Langmuir isothermal adsorption model and the adsorption process is single molecular layer chemical adsorption. The saturated adsorption capacity is 36.845 9 mg/g in 15 ℃,38.550 5 mg/g in 25 ℃,40.617 4 mg/g in 35 ℃. The increasing temperature is beneficial to the adsorption. ③In the case of volume concentration of sulfuric acid 18%,flow rate 3 mL/min and desorbent dosage 2.67 bed volumes,the ammonia nitrogen desorption rate of adsorption saturated resin was higher than 99%. T-42 resin can effectively remove ammonia nitrogen from wastewater,and sulfuric acid can desorb and regenerate the resin which adsorbs ammonia nitrogen.

【基金】 国家自然科学基金项目(编号:51774215);湖北省自然科学基金杰出青年项目(编号:2018CFA068)
  • 【分类号】X703
  • 【被引频次】2
  • 【下载频次】149
节点文献中: 

本文链接的文献网络图示:

本文的引文网络